NITTY GRITTY STYLE VAC SWEEP REPLACEMENT KIT There are two styles of Vac Sweep liners. Those for the manual style machines and those for the pump style machines. Manual style feature a peel and stick pressure sensitive adhesive. Pump style is a two piece set. 1. Vac Sweep Liner 2. Die cut peel and stick adhesive with holes for fluid to pass through. To replace your Vac Sweep Liner: 1. Remove the old worn Vac Sweep Liner. 2. Remove any old adhesive. This can best be done with a commercial adhesive remover or mineral spirits until the surface is clean smooth and shiny again. For the Pump machine , apply the die cut adhesive strip to each side making sure that the pump holes line up with the holes in the strip. Now peel the front side paper off exposing the opposite side adhesive. For the Manual machine peel the paper backing from the Vac Sweep Liner. For all machines slide the Vac Sweep onto the guide card until it stretches out flat, with its sides touching the guide card. Insert the guide card into the slot on the suction bar and transfer the Vac Sweep on to the bar. Remove the Guide and press the Vac Sweep down firmly.